Check to see if the cable is damaged or kinked. If the issue persists, I would do a hard reset and power drain to see if that will resolve the issue. To eliminate other causes, unplug the USB or phone cable (fax) for testing purposes if attached, Leave the printer on and unplug the power cable from the printer and wall outlet for 60 seconds.
how re-enable ethernet in BIOS? to solve network cable I have a Dimension xps800 with xp, and I keep getting message "network cable unplugged". I know it is not -- borrowed a laptop and plugged it in -- worked fine. I changed the position of the card on the motherboard, then I replaced the ethernet card, -- same message. The card shows up fine in … Ethernet Cable Unplugged After Windows 10 upgrade Aug 17, 2015
Resolve The Network Cable Is Unplugged Error
Ethernet Network cable unplugged after disabling "Auto
Ethernet Status: Cable Unplugged, while i… - Apple Community
My Ethernet adapter, a Realtek 10/100, works on boot-up. At some random point it stops working. It could be days later, it could be after waking up, it could be within an hour of a boot without sleep. "Network Connections" shows the adapter as enabled but unplugged. Messages Indicating that a Network Cable is Unplugged. Under Windows 2000 and later, when a new Virtual Network Adapter is created, an icon is displayed in the task tray at the lower right of the task bar and "A network cable is unplugged." message is displayed. This is normal operation. These steps are meant to troubleshoot the problem when you get the message even when a network cable is plugged to the NIC. · Check the cable as this message is a kind of information to check the cable going bad. Try a different cable. · Check the cable length, try limiting it to less that 6 ft. WiFi says it’s working fine but it says the Ethernet network cable is unplugged. I don’t have a desktop computer I only have two laptops which means I can’t directly plug in the Ethernet cable into the laptop to see if it’s working correctly. 2. Change settings in Network for "Configure IPv4" from DHCP to Manually - it helped for a second or two after reboot - the Ethernet showed 'connected' but in a second it turned back to cable unplugged. 3. Reset PRAM/NVRAM - helped for a few seconds, after startup was ethernet working but in a moment showed Cable Unplugged again.